Analysis of Vacuum Sintering Furnace
Min.Order Quantity: 1 Set/Sets Analysis of Vacuum Sintering Furnace
Supply Ability: 2 Set/Sets per Month Analysis of Vacuum Sintering Furnace
Payment Terms: L/C,T/T,
Price: Online consultation
- Product Details
- Technical Parameters
- Send Inquiry
Analysis of Operation Procedures of Vacuum Sintering Furnace
It is necessary for vacuum sintering furnace to operate well in use. Today we will teach you the operation steps of vacuum sintering furnace.
1. Check the source of water, power and gas;
2. Close the system power supply and heating power supply, start the control button, and start the preheating diffusion pump.
3. Programming and parameter checking of temperature control meter;
4. Opening door feeding;
5. Close the furnace door and exhaust valve to start rough pumping, when will the front valve open?
6. Open the main valve and work at this time.
7. When the vacuum is heated, the heating begins.
8. During the sintering process, the induction coil should be observed at any time from the side of the furnace body to see whether the arcing occurs or not. If abnormal phenomena are found, the relevant personnel should be immediately reported to deal with them.
9. When the heating is over, the cooling lamp flashes to give an alarm, and the alarm is relieved, and the cooling state (upper and lower limits of the pneumatic pressure gauge) is entered.
10. When the cooling temperature reaches the outlet temperature, the fan stops running.
11. After sintering, stop the frequency conversion, press the stop frequency conversion switch, the inverters stop working, disconnect the intermediate frequency power supply and disconnect the main power supply.
The above is about the analysis of the operation steps of vacuum sintering furnace, hoping to provide you with help.
Your request will be answered within one working day.