Liquid Ring Vacuum Pump for Paper Industry

The 2BE3 series water ring vacuum pump and compressor are designed and manufactured by our company in combination with foreign advanced technology. They can not only save energy, but also work continuously for a long time.

In the case of coarse vacuum, liquid ring vacuum pump requirements are very strict. Therefore, 2BE3 series products are specially designed for pumping various gases. They are widely used in many industries, such as paper making, mining, power station, chemical industry and so on.

 

 

The 2BE3 series can be driven by various components, such as v-belt, synchronous motor, gearbox, etc. To save space, the 2BE3 series pumps can drive two or more sets of up to four motors simultaneously.

When the middle wall is set in the shell, the pressure tolerance on both sides is lower than 80kPa, and the two parts can work under different vacuum conditions. Therefore, one pump can work like two. This effectively improves the flexibility of product operation.

 

 

 

· large inspection ports on both sides of the end cover allow easy observation of tolerances, corrosion conditions and defects.

· same diameter flanges are used on top and side of 2BE3 series pumps. It is more convenient to connect 2BE3 series pump.

· all bearings are imported to maintain accurate positioning and high stability during pump operation.

 

· the impeller is made of QT400 ductile iron or steel plate to ensure the stability of the pump in various harsh environments and effectively extend the service life of the pump.

· the housing is made of steel or stainless steel plate to extend the service life of the 2BE3 series pumps.

· the shaft sleeve is made of stainless steel plate, making the service life of the pump 5 times longer than ordinary materials.

 

· v-belt pulley (when the pump is driven by belt) is used for high-precision belt pulley with conical bushing to maintain the reliability of the pump and extend its service life. It is also easy to carry out mantle and removal.

· the unique design of setting the separator above the pump can save space and effectively reduce noise.

· all spare parts are cast by resin sand, making the pump surface very smooth. Therefore, there is no need to cover the surface of the pump with putty and effectively dissipate heat.

· mechanical seals (optional) are imported to avoid leakage during long working hours.