Turbine oil filter advantages
The turbine oil filter is a new generation of turbine oil purification products, which has absorbed the new oil purification technology achievements at home and abroad, and integrated the condensation, condensation and vacuum oil purification technologies. The product has reasonable design, compact structure and convenient operation.
The combination of coalescence and vacuum oil purification, circulating heating and control of high and low temperature on display can effectively solve the problem of oil emulsification under high temperature condition and make the water contained in it evaporate completely. The precision filter element is selected and the filtration precision is less than 5 μ M.
It is composed of gear wheel pump, filter, safety valve, oil return valve, filter bed, rear bracket, chassis, pull rod, coupling, and motor. The gear pump, coupling and motor are installed on the chassis, and the filter is installed on the front side of the gear pump. The oil return valve is installed on the filter, and the filter bed is installed above the gear pump, in which the filter plate frame alternately forms the filter chamber. The filter paper is sandwiched between the filter plate and the filter frame.
The inlet and outlet hose is connected to the inlet and outlet pipe joint. When the oil is inhaled from the oil inlet of the filter, the larger particles are removed through the filter before entering the gear pump. Driven by the motor, the gear pump rotates to produce extrusion force, which makes the oil enter into the filter bed and permeates the filter paper to filter the oil. Then drain the fluid from the oil outlet pipe. When the oil pressure exceeds the specified value.
The safety valve is started immediately, so that the oil circulates in the oil pump, and the oil pressure does not rise any more, so as to ensure the safety of the equipment. The oil sample valve is used to take oil samples for pressure test and other physical and chemical performance tests. This machine adopts chassis roller structure. It can be moved by pulling the pull rod manually.
The combined use of air-cooled condensing and vacuum unit can effectively reduce the amount of oil foam, fully remove the separated moisture, and directly discharge it under the operation state without shutdown operation. The product has a long design life and high operation efficiency. After the inspection of relevant departments, the first pass rate reaches the relevant standards. It can run synchronously with the steam turbine unit and purify the stored turbine oil. It is the product of the majority of power plants and industrial and mining enterprises.
The vacuum oil filter mainly aims at the characteristics of high moisture content, high impurity mass, easy emulsification and oil foam formation under the condition of vacuum oil purification. It adopts coalescence and vacuum dehydration technology, rapid separation, circulating heating, demulsification and complete water removal. The use of precision filter element, five levels of layer by layer filtration, prolong the service life of filter element, ensure the filtering accuracy requirements.
The main parts of the equipment are made up of primary filter, heater, two stage filter, coalescing filter, fine filter, oil suction pump, oil drain pump, condenser, cooler, foam device, vacuum unit and electrical control cabinet.