Need help? call us 86-21-50878190


Welcome to our Online Store!



Precautions for vacuum furnace heating process

Matters needing attention during the heating process of vacuum furnace:

1, to avoid heat treatment products, especially copper, aluminum, zinc, tin, lead, contact with electric heating elements, such as whether it is a fine powder, liquid or steam, etc., to prevent surface erosion in the electric heating body formation "ma pit", smaller cross section, and finally overheat and burn out.


2. When testing the uniformity of furnace temperature, it is necessary to pay attention to the positioning and binding mode of temperature contact points, as well as the distance from the heating element.

Vacuum gas quenching3.jpg

Box type resistance furnace furnace often (at least once a month), brooms with brush or compressed air, vacuum cleaners clean furnace and put aside brick, such as to prevent impurities such as furnace oxide skin off on the electric heating element, short-circuit, even burning brick. The bottom plate, crucible, furnace and other heat-resistant steel members are used for a period of time. If the impurities such as iron oxide are not removed in time, it will melt and react with the refractory brick to melt the furnace wire.


3. When the vacuum furnace is heated up, it cannot open the furnace door for a long time. When the temperature higher than 400 ℃, the rapid cooling is not allowed. In the case of high temperature and hot and cold changes of electric heating elements, it is easy to oxidize the skin. For the heating furnace of molybdenum, EI often pay attention to the use and maintenance shall be cooled to below 200 ℃ can stop shielding gas.

gas quenching 124.jpg

4. The outlet rod and wire clip should be in good contact, and the outlet rod should be smooth with the clamp. There cannot be aglow phenomenon leads to great, when the power supply line clip of warming is highest do not exceed 60 ℃. It is noted that because of the thermal expansion and shrinkage and creep elongation of the heating stop furnace, the bolts of the rod connecting clamp are easy to be oxidized and loose, forming a hollow short circuit, which should be checked and tightened regularly.


Vacuum furnace automatic control of reasonable design, high degree of automation, good reliability, which can effectively ensure the production of efficient, safe, and give full play to the high reliability of PLC, anti-jamming, convenient debugging, automate the brazing process, so as to reduce the labor intensity of operators. At the same time, it solves the problem of long period and serious resource waste, and realizes saving time and energy saving, which has high economic and social benefits.

Vacuum gas quenching 1.jpg

Related Products

Low price Industrial Circulating water v

Low price Industrial Circulating water v

Product Details

HIQ-1400VF vacuum atmosphere furnace

HIQ-1400VF vacuum atmosphere furnace

Product Details

Thermal evaporation vacuum coating machi

Thermal evaporation vacuum coating machi

Product Details

transparent high pressure booster diffus

transparent high pressure booster diffus

Product Details